Router Bits and Woodworking Products

Average Customer Rating: (2 reviews)
Add your own review for this product

By Bob Justison (Newark DE US)

I recently purchased this router bit set to build a new table top for an old gate leg table. The bits matched perfectly. I also enjoyed watching the instructional video.

By Walt Walsh (Exton PA )

This is a very satisfying project that is not difficult if you follow the plans and watch the video. I made the first table for a daughter living off campus in a small apartment. The legs and apron were beech and the top ¾ inch birch plywood with a 2 ½ solid wood edge.

For simplicity, leafs were rectangular. My legs were tapered with a shop made jig. The roll top edges were perfect after adjusting the set ups with a few test pieces. I didn’t like the underside stops so I drilled 5/8 shallow hole in underside of the leaf and a corresponding hole in the gate leg as an alternative. I used the triple cutter half round and cove that I had previously purchased and loose tenons instead stubs.

Add your own review for this product